Module 6 : Traffic Intersection Control
Lecture 32 : Traffic Rotary
1 2 3 4 5 6 7 8
 

General

Advantages and disadvantages

The key advantages of a rotary intersection are listed below:
  1. Traffic flow is regulated to only one direction of movement, thus eliminating severe conflicts between crossing movements.
  2. All the vehicles entering the rotary are gently forced to reduce the speed and continue to move at slower speed. Thus, none of the vehicles need to be stopped,unlike in a signalized intersection.
  3. Because of lower speed of negotiation and elimination of severe conflicts, accidents and their severity are much less in rotaries.
  4. Rotaries are self governing and do not need practically any control by police or traffic signals.
  5. They are ideally suited for moderate traffic, especially with irregular geometry, or intersections with more than three or four approaches.
Although rotaries offer some distinct advantages, there are few specific limitations for rotaries which are listed below.
  1. All the vehicles are forced to slow down and negotiate the intersection. Therefore, the cumulative delay will be much higher than channelized intersection.
  2. Even when there is relatively low traffic, the vehicles are forced to reduce their speed.
  3. Rotaries require large area of relatively flat land making them costly at urban areas.
  4. The vehicles do not usually stop at a rotary. They accelerate and exit the rotary at relatively high speed. Therefore, they are not suitable when there is high pedestrian movements.

Guidelines for the selection

Because of the above limitation, rotaries are not suitable for every location. There are few guidelines that help in deciding the suitability of a rotary. They are listed below.
  1. Rotaries are suitable when the traffic entering from all the four approaches are relatively equal.
  2. A total volume of about 3000 vehicles per hour can be considered as the upper limiting case and a volume of 500 vehicles per hour is the lower limit.
  3. A rotary is very beneficial when the proportion of the right-turn traffic is very high; typically if it is more than 30 percent.
  4. Rotaries are suitable when there are more than four approaches or if there is no separate lanes available for right-turn traffic. Rotaries are ideally suited if the intersection geometry is complex.