Operational Amplifiers:

The operational amplifier is a direct-coupled high gain amplifier usable from 0 to over 1MH Z to which feedback is added to control its overall response characteristic i.e. gain and bandwidth. The op-amp exhibits the gain down to zero frequency.

Such direct coupled (dc) amplifiers do not use blocking (coupling and by pass) capacitors since these would reduce the amplification to zero at zero frequency. Large by pass capacitors may be used but it is not possible to fabricate large capacitors on a IC chip. The capacitors fabricated are usually less than 20 pf. Transistor, diodes and resistors are also fabricated on the same chip.

Differential Amplifiers:

Differential amplifier is a basic building block of an op-amp. The function of a differential amplifier is to amplify the difference between two input signals.

How the differential amplifier is developed? Let us consider two emitter-biased circuits as shown in fig. 1.

Fig. 1

The two transistors Q₁ and Q₂ have identical characteristics. The resistances of the circuits are equal, i.e. R_E1 = R _E2, R_C1 = R _C2 and the magnitude of +V_CC is equal to the magnitude of –V_EE. These voltages are measured with respect to ground.

To make a differential amplifier, the two circuits are connected as shown in fig. 1. The two +V_CC and –V_EE supply terminals are made common because they are same. The two emitters are also connected and the parallel combination of R_E1 and R_E2 is replaced by a resistance R_E. The two input signals v₁ & v₂ are applied at the base of Q₁ and at the base of Q₂. The output voltage is taken between two collectors. The collector resistances are equal and therefore denoted by R_C = R_C1 = R_C2.

Ideally, the output voltage is zero when the two inputs are equal. When v₁ is greater then v₂ the output voltage with the polarity shown appears. When v₁ is less than v₂, the output voltage has the opposite polarity.

The differential amplifiers are of different configurations.

The four differential amplifier configurations are following:

1. Dual input, balanced output differential amplifier.
2. Dual input, unbalanced output differential amplifier.
3. Single input balanced output differential amplifier.
4. Single input unbalanced output differential amplifier.

Fig. 2

These configurations are shown in fig. 2, and are defined by number of input signals used and the way an output voltage is measured. If use two input signals, the configuration is said to be dual input, otherwise it is a single input configuration. On the other hand, if the output voltage is measured between two collectors, it is referred to as a balanced output because both the collectors are at the same dc potential w.r.t. ground. If the output is measured at one of the collectors w.r.t. ground, the configuration is called an unbalanced output.

A multistage amplifier with a desired gain can be obtained using direct connection between successive stages of differential amplifiers. The advantage of direct coupling is that it removes the lower cut off frequency imposed by the coupling capacitors, and they are therefore, capable of amplifying dc as well as ac input signals.

GOTO >> 1 || 2 || Home