FABRIC MANUIFACTURE - I

(MCQ : MODULE 4 - WARPING )

Question 1: The magazine creel is employed for

Long run of the same warp
Quick change over from one warp to another
Saving space
Saving energy.

Question 2: The headstock is movable in

Truck creel
Duplicated creel
Magazine creel
Swiveling creel

Question 3: Transfer failure is relevant in case of

Truck creel
Duplicated creel
Magazine creel
Swiveling creel

Question 4: If the creel capacity is 680 then the maximum number of ends on the warper’s beam in case of magazine creel would be

340
680
1360
2720

Question 5: With one break per million meters of yarn wound, a beam warper running from a 600 end creel of 15 tex yarn would stop every

1500 m
1567 m
1600 m
1667 m

Question 6: Sectional warping is a

Two step process and less popular than direct warping
Single step process and used for customized production
Two step process and beaming speed is more than direct warping
Two step process and used for customized production

Question 7: Sectional warping is considered more practical than beam warping

For executing large orders
For small lots
For spun yarns
When sizing is considered necessary

Question 8: The angle of the conical portion of the drum in sectional warping is around

0⁰-4⁰
6⁰-20⁰
30⁰-45⁰
45⁰-60⁰

Question 9: For increased taper angle on a sectional warping machine, one could require to

Increase the traverse speed
Decrease the traverse speed
Increase the warping speed
Decrease the warping speed

Question 10: Expandable reeds are used to

Expand the width of the warping machine
Control the warping tension
Ensure desired spacing between two ends
To repair warp breakage during warping

 

Check Score