Module 1 : Site Exploration and Geotechnical Investigation
Lecture 4 : In-situ tests [ Section 4.1: Penetrometer Tests ]
   
When a casing is used in borehole, it should be ensured that the casing is driven just short of the level at which the SPT is to be carried out. Otherwise, the test gets carried out in a soil plug enclosed at the bottom of the casing.
 
When the test is carried out in a sandy soil below the water table, it must be ensured that the water level in the borehole is always maintained slightly above the ground water level. If the water level in the borehole is lower than the ground water level, ‘quick' condition may develop in the soil and very low N values may be recorded.
 
   
  In spite of all these imperfections, SPT is still extensively used because
the test is simple and relatively economical.
it is the only test that provides representative soil samples both for visual inspection in the field and for natural moisture content and classification tests in the laboratory.
 
   
  SPT values obtained in the field for sand have to be corrected before they are used in empirical correlations and design charts. IS: 2131-1981 recommends that the field value of N be corrected for two effects, namely, (a) effect of overburden pressure, and (b) effect of dilatancy.
   
(a) Correction for overburden pressure
 

Several investigators have found that the penetration resistance or the N value in a granular soil is influenced by the overburden pressure. Of two granular soils possessing the same relative density but having different confining pressures, the one with a higher confining pressure gives a higher N value. Since the confining pressure (which is directly proportional to the overburden pressure) increases with depth, the N values at shallow depths are underestimated and the N values at larger depths are overestimated. To allow for this, N values recorded from field tests at different effective overburden pressures are corrected to a standard effective overburden pressure.

 
1
5